CNCMACHINESINDIA 5821819d9ec6682e688dbcbd False 25 15
OK


CNC / DNC Settings for Fanuc Oi

ParameterValueComments 
 
000000000010 
00200 
010000100000 
010110000001 
01020 
01039Baud rate - see table below for valid options.
 6 = 300
7 = 600
8 = 1200
9 = 2400 * (recommended)
10 = 4800
11 = 9600
 
TV Check00 = TV Check OFF (1= TV Check ON - Never enable TV Check)
Punch Code11 = ISO (0=EIA Never use EIA)
I/O Channel0 
   
Drip Feed ?

Select Auto (DNC) mode on the control - Press Cycle Start.
Then go to the computer, prepare the program and click 'Send'. When data begins to flow the machine will start moving.

RS232 Cable.
9pin computer to 25pin CNC

Cable shown here works with xOn/xOff (DC1/DC3) flow control and RTS/CTS (Hardware flow control so should work in most cases.

But if you're sure your CNC does not use any flow control - or requires only xOn/xOff then you may use the the simpler 3 wire cable. Diagram..



Other Pages

Contact

No : 4, Pandara Street, Poonamallee, - 600056
+91 8033767367  or   or    (Trouble calling us?)
Share Tweet
False

SUBSCRIBE

5821819d9ec6682e688dbcbdCNCMACHINESINDIA57c3c1a65d64370d7cf4eb17